Frequency Tables & Switch Settings
4 stars based on
If you want set options rangeblock allow or block web requests based on the IP addresses that the requests originate from, create one or more IP match conditions. Later in the process, when you create a web ACL, you specify whether to allow or block requests from those IP addresses.
If you want to allow some web requests and block others based on the IP addresses that the requests originate from, create an IP match condition for the IP addresses that you want to allow and another IP match condition for the IP addresses that you want to block. When you add an IP match condition to a rule, you also can configure AWS WAF to allow or best forex broker switzerland web requests that do not originate from the IP addresses that you specify in the condition.
The name can contain only alphanumeric characters A-Z, a-z, or the following special characters: You can't change the name of a condition after you create it. Here are some examples:.
To specify the range of IPv4 addresses from To specify the range of IPv6 addresses from You set options rangeblock add an IP address range to an IP match condition or set options rangeblock a range.
To change a range, add a set options rangeblock one and delete the old one. If you want to delete an IP match condition, you must first delete all IP addresses and ranges in the condition and remove the condition set options rangeblock all the rules that are set options rangeblock it, as described in set options rangeblock following procedure.
If the list of rules using this IP match condition is empty, go to step 6. If the list contains any rules, make note of the rules, and continue with step 5. To remove the IP match condition from the rules that are using it, perform the following steps:. In the right pane, select the IP match condition that you want to remove from the rule, and choose Remove selected condition.
Which Should I Choose? Complete the Prerequisites Step 2: Create Rules Step 3: Create set options rangeblock Rule Group Step 4: To specify the IPv4 address To specify the IPv6 address 0: